Sandpiper S1F Non-Metallic Bedienungsanleitung PDF herunterladen (Seite 19)

s1fnmdl3sm-rev0614

4: AIR END

sandpi p erpump .com

Model S1F Non-Metallic • 16

INTERMEDIATE REPAIR PARTS LIST

Item Part Number Description Qty

4 114.024.551 Bracket, Intermediate 1

114.024.559 Bracket, Intermediate 1

6 135.034.506 Bushing, Plunger 2

27 560.001.360 O-Ring 2

30 620.020.115 Plunger, Actuator 2

32 675.042.115 Ring, Retaining* 2

34 720.004.360 Seal, Diaphragm Rod 2

*Note: It is recommended that when plunger components

are serviced, new retaining rings be installed.

Pilot Valve Assembly

IMPORTANT

When the pumped product source is at a higher

level than the pump (ooded suction condition),

pipe the exhaust higher than the product source

to prevent siphoning spills. In the event of a

diaphragm failure a complete rebuild of the

center section is recommended.

Intermediate Assembly Drawing

Step 1: Remove plunger, actuator (30) from center of

intermediate pilot valve cavity.

Step 2: Remove Ring, Retaining (32), discard.

Step 3: Remove bushing, plunger (6), inspect for wear

and replace if necessary with genuine parts.

Step 4: Remove O-Ring (27), inspect for wear and

replace if necessary with genuine parts.

Step 5: Lightly lubricate O-Ring (27) and insert into

intermediate.

Step 6: Reassemble in reverse order.

Step 7: Remove Seal, Diaphragm Rod (34).

Step 8: Clean seal area, lightly lubricate and install new Seal,

Diaphragm Rod (34).

MODEL SPECIFIC

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25 26

Keine Kommentare

Sandpiper S1F Non-Metallic Bedienungsanleitung Seite 19